Which snowboard bindings are these screws compatible with?
Caution: these screws are suitable for the vast majority of bindings, but you need to check that the disc of your binding is not too thin or too thick.
To do this, remove your binding and take the central disc, position 1 screw and 1 washer in one of the slots. Measure the length of the screw protruding from the disc.
If this length is greater than 6 mm, you will deform the base of your snowboard in front of each screw => do not fit these screws to this binding.
Risk if the disc of your fastener is too thin for these screws
The screws will be too long, forcing on the sole and deforming it.
Risk if the disc of your fastener is too thick for these screws
The screws will be too short. At best, you won't be able to screw them in, but the worst-case scenario would be that you only screw in 1 or 2 turns of thread.
And then you'd be in danger, as the screw's resistance will be weak, and you'll risk tearing off a fastener in the middle of a ride.
