The Roth diving block
The block consists of :
- a steel bottle,
- a two-outlet yoke tap,
- PVC cap,
- carrying handle,
- protective net.
Base and handle
The PVC base is adapted to the diameter of the bottles, allowing them to be held in an upright position. A hole in the bottom of the bottle allows residual water to be drained off for easy disassembly. The carrying handle is made in 2 parts, allowing assembly and disassembly without unscrewing the tap.
Maintenance
It is forbidden to carry out repairs on the cylinder by welding, riveting or drilling, or any operation involving the removal of material or a significant rise in cylinder temperature (maximum 300°C).
Routine maintenance
It's advisable to rinse the block daily with fresh water, not forgetting the bottom (the hole in the PVC base): this removes seawater and sand, preventing paint abrasion and premature corrosion. Immediately touch up any areas of chipped paint caused by impact or abrasion.
Do not weld, rivet or drill on the bottle, or carry out any other operation involving the removal of material or the raising of temperature.
Periodic maintenance
These units are subject to regular inspections as required by the legislation in force in the country of use. These checks must be carried out by authorized establishments or individuals.
In France, the decree of March 15, 2000 makes annual visual inspection by TIV mandatory, and requalification at 5 or 2 years.
Storage
Before prolonged storage, it is advisable to carry out the maintenance operations described above, as well as rinsing the inside of the bottle with fresh water and drying it thoroughly. In addition, we strongly recommend:
-storing the cylinder upright in a clean, dry, temperate place,
-keep a low residual pressure inside the cylinder to evacuate any dust and condensation that may have entered through the valve opening.
Recommendations 1/2
Never gonflez a lift bag with bare fittings (without regulator).
- Never leave an empty cylinder with the valve open.
- Never leave a cylinder exposed to spray, waves, or swimming in the water at the bottom of the boat.
Recommendations 2/2
- If possible, keep some residual air pressure in the cylinder to evacuate any water that may have entered through the valve opening (if the cylinder has been completely emptied during a dive, leave the regulator in place until it is safe).
- Never empty a cylinder quickly, as this will cause the valve to ice up and condensation to build up inside the cylinder.
Dimensions
Height without tap: 52 cm.
Height with tap: 68 cm.
Diameter: 20.3 cm.
Payment in 3 instalments is possible from a basket value of CHF 50 and requires the approval of our partner CembraPay. You will be able to choose this method of payment, and consult the terms and conditions and applicable fees when finalizing your order.
