Roof rack compatibility
Compatible with ISO11154-approved roof bars for a load > 75kg (dynamic weight).
The distance between the roof and the top of the roof bar must be greater than 7.5cm and the width of the roof bar tube must be less than 9.5cm (see diagrams in the photos in this product data sheet).
Check the tightness of your roof bars and tent each time you use it.
Not compatible with longitudinal roof bars.
What are dynamic and static loads?
This tent requires a load capacity of 75kg, which corresponds to a so-called "dynamic" load, i.e. when the vehicle is moving. When the vehicle is stationary, the maximum static load capacity is much higher.
Don't worry, once you've set up the tent and stopped, your roof bars will be able to support the tent, as well as the weight of the people inside (200kg in total).
Assembly
Ideally, 4 people are required to set up the tent.
Watch the setup video and/or the instructions included in the tent cover.
Remove the tent cover, then unclip the two side buckles.
Grab the ladder and use it to tilt the tent.
Adjust the ladder so that the tent is flat, and secure the rungs - they must be locked before you can set up the tent.
Tilt the 3rd tray before inflating your tent, respecting the pressure indications (7psi).
Why a more compact roof tent?
With its 3-panel structure, we've made it even more compact to:
Free up space on the roof bars when you're on the road, so you can take sports equipment with you to your vacation destination (depending on the size of your vehicle).
Make it easier to install on the roof bars.
Reduce wind load, and therefore fuel consumption, while you're on the road.
Make it easier to store.
Be better suited to smaller cars, with less overhang.
The product contains :
- 1 inflatable structure tent (chamber + flysheet) (compatible with pump 8243066 and 8601387)
- 1 built-in 5 cm foam mattress
- 1 aluminium ladder, maximum 2.50 m unfolded
- 1 screw kit (4 plates + screws and washers)
- 1 shoe pocket
- 1 removable storage pocket
- 1 2 m hose extension
- 1 cover
Please note: THE PUMP IS NOT INCLUDED.
SAV: Don't throw away, repair!
As designers and enthusiasts of our playground, we are concerned about the durability of our products, which is why all our tents are designed to be repairable.
You will find the following after-sales parts for this tent:
- the cover
- the mattress cover
- the tarpaulin
- TPU flange
- screw kit
Usage restrictions 1/2
WARNING: NEVER GET INTO THE TENT IF THE RACK BARS ARE NOT ALL LOCKED.
DANGER OF FALL. (see instructions)
Do not use the ladder for any purpose other than its intended use.
COMMON MISTAKES:
Forget to insert the transport bag in the rail before starting.
Overtightening screws (risk of damaging the rails and/or aluminum floor)
Forget the pump.
Restrictions on use 2/2
Do not ride with the tent open.
Do not ride if the bias of the cover is not tucked into the front rail.
Do not use accessories other than those supplied with the tent.
Always set up the tent on a flat surface so that it is stable.
Do not set up on vehicles with glass roofs.
Do not pitch the tent into the wind.
Keep the instructions accessible.
Do not put all your weight on the tilting floor not held up by the ladder.
Components :
Bedroom component: 300-denier ripstop polyester.
Double-roof: 150 denier solution-dyed polyester.
Warranty
5 years.
All our tents can be repaired in the workshop of your Decathlon store.
